J&M Industries PC Repair. We do our business online but we thought we would offer our services in town as well. Here is a link to your eBay site so you can see a little of what we do: http://www.ebay.com/usr/j.m.industries?_trksid=p2047675.l2559

Does your Laptop have the "NO Video" "No BOOT" "On then OFF" issues?
We can fix that!
We have repaired thousands of laptops with all of these various issues with a very high success rate. Our customers are always satisfied with our services and we're sure you will be too.

Symptoms include the following:

Weird colored screen (grey, green, red etc..
Scrambled or pixelated screen
Divided split screen (2 screens up to 12 split screens)
Screen black however backlit
Screen black with no back light
Turns on then shuts off immediately
Turns on, black screen and keeps restarting by itself
White or grey screen sometimes with horizontal lines
Press power button and nothing happens what so ever (seems dead.)
Intel models boot to back light but no screen
Can't load Nvidia driver, can only run in VGA mode
Screen works but no WiFi (does not show up in device manager)
and much more, if you don't see your symptom on this list, email me

Customer satisfaction is our #1 priority and sole purpose for these services and we strive to attain that the best we can.

A little bit about our process and equipment.

Upon the arrival of the laptop, we use a humidity analyzer tester and put the motherboard on our Honoton R392 and "bake" the boards until the moisture is completely out of them. Attempting a repair with moisture in motherboards can cause more issues than there previously were. After that we use the proper reball profiles to reball the boards using KingBo flux. We also use an inspection scope to further inspect the boards.

Afterwards the board is cleaned in an ultrasonic cleaner to remove all the excess flux and dirt from the board, which could cause problems if it's not properly cleaned and removed.

Once the board is cleaned and finished on the station, we apply thermal compound / thermal pad to the chips and reassemble the board to insure that it's working and 100% fully functional.

(With the reballing, we use leaded solder balls).

We have a lot of other equipment and stencils for almost every graphics chip out there so there's usually no need for us to order any parts, that is unless the chip is bad or if it's a rare stencil that we don't have.

The process usually takes anywhere from 1-4 hours, depending on the issues your laptop is suffering from. Turn around time is fast, usually within 24-72 hours, depending on how many laptops we have in at the moment.
Everything is done on anti-static mats and anti-static protocol is always used.
We go the extra mile for our customers and do our best to make sure you're satisfied with the repair.
If new parts are needed then we will contact you with the prices and discuss how you want to proceed.
We are highly trained, certified, and very experienced. We will do our best to get your unit up and running again.
We have a 99% success rate but not everything is repairable, but we will do our best to avoid having to replace your logic board.
If we can't fix your problem, you pay nothing.
We do other repairs like your standard virus removal, tune-ups, etc. You name it, we can most likely do it. Give us a call or text us at (850) 426-7013 or (850) 341-0499 and we'll do our best to take care of it. We've seen almost every problem under the sun so feel free to ask us if you have any questions.
No heat guns, towels, or hair dryers are used in our repairs, professional equipment only.